DESCRIPTION:
The Esco Medical MIRI® family`s multiroom IVF incubators are intended to be used to pro-vide a stable culture environment at or near body temperature and CO2/N2 or premixed
MIRI® II-12 Multiroom IVF incubators User Manual Rev. 4.0 11
gases and humidification for the development of gametes and embryos during in vitro fertilization (IVF) / assisted reproduction technology (ART) treatments.
FEATURES:
Twelve (12) completely independent chambers
- The chambers are separate from one another. There is no effect on the remainder of the system from any disruption in one chamber, such as a temperature reduction after opening the lid. The temperature in the culture chambers and the lids can be controlled and regulated as well. The top and the bottom of each chambers are separated with a PET layer so that the lid temperature would not affect the bottom.
Advanced gas system
- The incubator needs 100% CO2 and 100% N2 to control the CO2 and O2 concentrations in the culture chambers. A dual-beam infra-red CO2 sensor with extremely low drift rates controls the CO2 levels. On the other hand, a chemical, medical-grade oxygen sensor controls the levels of the O2 in the system.
Heated lid
- Heated chamber lids prevent condensation, increase temperature control, and ensure that the temperature level is the same all over the chamber.
Fast temperature and gas recovery
- Temperature recovery <1 min.
- Gas recovery <3 min.
- The MIRI® II-12 incubator is fitted with 12 gas sample ports that allow the user to validate gas concentration by sampling gas from the individual compartment.
LED display
- Large LED display that is easy to read and allows you to navigate easily through the menus.
Optimized heating plates
- The heating plates are optimized for easy use with all known manufacturers of culture dishes.
- Petri dish location: found in a compartment that is easy to reach and safe because of the compartment numbering and the ability to write on the white lid with a pen.
The software
- It runs on the built-in touchscreen in MIRI® II-12 version.
-
The software contains logging functions for long-term data logging and storage.
USB module
- This enables the quality control data to be transferred for off-site evaluation.
A pH sensor port
- The user can plug any standard BNC pH probe into the unit and measure the pH in the samples at will.